SCH Collectors Installation & Operation Manual
30
4
Collector Installation
Figure 4-6 Secure Collector
SQUARE DISK
HEX BOLT
7. Position the collector on the horizontal bars so that the
collector
overhangs
approximately
5mm
(.2")
(FIG.
4-7).
Figure 4-7 Position Collector on Horizontal Bars
8. Connect the horizontal end brace to the collector
using the square disk, hex bolt, washer and nut on each
side of the collector (FIG. 4-8).
Figure 4-8 Connect Horizontal End Brace to Collector
CONNECT HORIZONTAL END BRACE
TO HORIZONTAL BAR
9. For
stacked series installations
repeat steps for
the top collector and install self tapping screws and
spacers to separate the top collector from the bottom
collector as shown in FIG. 4-9.
Figure 4-9 For Stacked Series Installations - Use Self
Tapping Screws and Spacers
USE SELF TAPPING
SCREWS AND SPACERS
TO SEPARATE THE TOP PANEL
FROM THE BOTTOM PANEL
10. Install top collector on the horizontal bars and slide it
onto the spacers (FIG. 4-10). Repeat Steps 7 and 8 for
the top collector.
Figure 4-10 Install Top Collector
INSTALL TOP COLLECTOR
12. For
side by side installations
repeat Steps 1 - 8 and install
horizontal hydraulic connections (see FIG. 4-12).
Figure 4-12 Install Horizontal Hydraulic Connections on
Side by Side Installations
5.1”
ENSURE COLLECTORS
ARE 5.1” APART
INSTALL
HYDRAULIC
CONNECTION KIT
SCH Collectors Installation & Operation Manual
11. Install end stacking brackets (FIG. 4-11).
Figure 4-11 Install End Stacking Bracket(s)
INSTALL END STACKING BRACKET
END STACKING BRACKET
INSTALLED
Make certain collectors are 5.1" apart.
NOTICE
Go to Step 12 for instructions on
side by
side installations
.
NOTICE
