Installation & Operation Manual
55
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING:
If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury, or loss of life.
A. This appliance does not have a pilot. It is
equipped with an ignition device which
automatic ally lights the burner. Do not try
to light the burner by hand.
B. BEF ORE OPERATING smell all around
the appliance area for gas. Be sure to
smell next to the floor because s ome gas
is heavier than air and will settle on the
floor.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electric switch; do
not use any phone in your building.
•
Immediately call your gas supplier from a
neighbor’s phone. F ollow the gas supplier’s
instructions.
•
If you cannot reach your gas s upplier, call
the fire department.
C. Use only your hand to move the gas control
switch. Never use tools. If the switch will not
move by hand, don’t try to repair it, call a
qualified service technician. Force or attempted
repair may result in a fire or ex plosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified
service technician to inspect the appliance and
to replace any part of the control system and
any gas control which has been under water.
OPERATING INSTRUCTIONS
1. STOP! Read the s afety information
above on this label.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the
appliance.
4. This appliance is equipped with an ignition
device which automatically lights the
burner. Do not try to light the burner by
hand.
5. Remove front door.
6. Move switch to the “OFF” position.
7. Wait five (5) minutes to clear out any gas.
If you then smell gas, STOP! F ollow “B”
in the safety information above this label.
If you don’t smell gas, go to next step.
8. Move the s witch to the “ON” position.
9. Install
front
door.
10. Turn on all electric power to appliance.
11. Set thermostat to des ired setting.
12. If the appliance will not operate, follow the
instructions “To Turn Off Gas To Appliance” and
call your service technician or gas supplier.
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the applianc e
if service is to be performed.
3. Remove front door.
4. Move the s witch to the “OFF” position.
5. Install
front
door.
LBL 233 9 REV C
Figure 10-2 Operating Instructions - Models 151 - 286
10
Start-up
(continued)
