33
ThE ProCESS For LIME SCALE rEMoVAL IS AS FoLLowS:
1. Turn off electrical disconnect switch.
2. Drain the heater following DRAINING instructions.
3. Open front panel.
4. Disconnect the element wiring. Try not to disturb the wiring
unnecessarily and reconnection will be easier.
5. Unscrew each element.
6. Remove the elements and gaskets from the openings.
• Use a twisting, pulling action to remove elements scaled beyond
the size of the tank openings.
• Brush loose scale from elements.
7. Lime scale removal:
• Place limed ends of heating elements into delimer and
allow scale to dissolve. Do not permit delimer or water to contact
heating element electrical terminals.
• Silicates, sulfates, and aluminates must be removed by scraping
or other mechanical means. Lime scale dissolvents will
not remove these types of scale which are occasionally
encountered.
oThEr SCALE rEMoVAL:
1. Flush cleaned ends of elements with water when deliming or
cleaning is completed.
2. Remove sediment and scale from the tank bottom through the
access provided by the element openings or drain valve opening.
• The cold water inlet valve and drain valve may be opened to
aid the cleanout process.
3. Clean remaining gasket material from tank and element flanges
Do not reuse original element gaskets.
4. Put new gaskets on each element and install into tank openings.
• Uniformly tighten element bolts. Torque to approximately
32 ft./lbs.
5. Attach element wires to connection points from which they were
removed.
6. Follow FILLING instructions to restore hot water service.
• Check for water leaks around elements and proper operation
when heater is filled.
• Close the front panel.
Summary of Contents for HC 119 Series 100
