LNS ITALIA s.r.l. Instruction manual series SC 500 page 11 di 21 –
05-2014
4.3 Preload siphon
Before using the spray cabin it is necessary to preload the drain trap as shown in the following steps:
- Remove the upper grille (Fig. 5a).
- Slowly pour about a liter of whole oil (do not use emulsions) in the collecting tray chips (5b).
- After a few minutes verify that the excess oil is drained into the container recovery (5c).
Fig.5d
Fig.5e
Fig.5f
"personal safety- unit integrity"
Failure of preload the siphon can compromise the life of the filters and the level of air
filtration in output.
Do not use emulsions but only neat oil for the preload of the siphon.
4.4 Using side tray
To use the side tray:
- Lift the tray by turning it around the hinge support
- Turn the holder and lock it in place between the two safety pins
- Check that the tray is fully locked in place.
"Personal safety – unit integrity"
In order to avoid damage to persons or property the maximum load that can be placed on
the tray-pieces is 8 kg.
Do not under any circumstances exceed the maximum load of 8kg.
Fig.5g
Fig.5h
Fig.5i
