LNS 326 S2, Startup Manual, Page: 10 / 17

START UP MANUAL 9
HYDROBAR EXPRESS 326 S2
Note :
Depending on
lathe
configuration,
there may be
other
parameters
available.
For further
information,
see chapter 8 /
point 5.
Example 3: Large-diameter profiled bars / special elements in the front rest.
Bar profile hexagonal
Bar diameter (acros adges) 18 mm
Guiding channel diameter 20 mm
Length of pieces to be machined 44.0 mm
Thickness of the cutoff tool 2.0 mm
Press the [
MENU
] key; the remote command displays the following text :
PARAMETERS RELATED TO START-UP
Press the [
ENTER ] key; the remote command displays the following text :
BAR STOCK DIAMETER :
On the keypad enter [18] (barstock diameter across edges)
Press the [
ENTER
] key twice, the remote command displays the following text :
GUIDING ELEMENTS DIAMETER
On the keypad enter [20]
Press the [
ENTER
] key twice, the remote command displays the following text :
INPUT OVERALL PART LENGTH
On the keypad, enter [46], which represents the sum of the bar length and the thickness of
the cutoff tool.
Press the [
ENTER
] key twice to store the data.
Press the [ ESC ] key to exit the set-up functions.
Press the key attributed to the icon
[PAGE DOWN]
.
The remote command displays the following text :
ADDITIONAL PARAMETERS RELATED TO START-UP
Press the [ ENTER ] key, the remote command displays the following text :
ROUND / PROFILED MATERIAL
Select [PROFILED] then, to save, press [ENTER] twice.
Remember – the standard guiding elements have been replaced by elements especially
adapted to the stock to be loaded.
When selecting this parameter, the front-rest adjustment will be so effected as to ensure that
the elements are touching when the front rest is closed (see point 3.2.5 of this manual).
The positioning cycle (Top Cut) cycle is also adapted to profiled stock.
Press the [ ESC ] key to exit the set-up functions.