42
b) Deleting the wireless switch socket’s programming
If necessary, you can delete all programs and settings that were previously saved in the wireless
switch socket in one step.
To do so, proceed as follows:
• Press the ‘
Ein/Aus
’ button (On/Off) on the wireless switch socket for at least 15 seconds.
• The LED on the wireless switch socket starts to blink and the device is now in programming
mode.
•
Briefly
press the ‘
Ein/Aus
’ button (On/Off) again.
• The LED goes out and the programming mode ends automatically.
All address settings have been deleted. The wireless switch socket no longer
responds to any remote control commands and must be programmed with a
house code and addresses again before it can be used, see section 8. c).
c) Other
The ‘FS20 ST-2’ wireless switch socket has other functions which can be used in connection with
other FS20 components (for example, a wireless remote control of the FS20 switching system),
such as a timer mode.
However, these functions
cannot
be used in connection with the ‘FS20 STR’
wireless thermostat, as this only uses the ‘on’ and ‘off’ commands.
If you intend to use with the wireless thermostat an existing ‘FS20 ST-2’ wireless switch socket
that has already programmed with any other command settings, you must first delete those
settings; see point b) above.
