16
The house code and addresses in the FS20 wireless control system are always programmed
on the transmitter only (for example, the ‘FS20 STR’ wireless thermostat).
The receiver (for example, the ‘FS20 ST-2’ switch socket) is set to program mode. The
transmitter is then activated and the house code and the address are transmitted to the
receiver.
Both the transmitter and the receiver return to normal operating mode when the transmission
is finished.
Please read section 8. c) for more on programming the house code and the
address of the ‘FS20 STR’ wireless thermostat.
The same applies for the ‘FS20 ST-2’ switch socket.
The wireless switch socket may have been preprogrammed to the wireless thermostat by the
manufacturer.
If this is the case, you can of course change the house code and address and
program it with your own settings.
To do this, proceed in the following sequence:
• Delete the wireless switch socket’s programming (see section 10. b)
• Program the house code and the address of the wireless thermostat (see section 8. c)
• Set the wireless switch socket to program mode (see section 8. c)
• Transmit the house code and address from the wireless thermostat to the wireless switch
socket (see section 8. c)
