13
4.6
Fixing and adjusting the vest and lap belts
The device is equipped with a vest and lap belts for securing the user's position in the chair. The vest and lap belts are
attached to the device with straps. In order to properly secure the vest, the straps should be threaded through the holes in
the mounting loops. The loops can be found in the upper and lower part of the backrest (Fig. 12). The length of the straps can
be adjusted by pulling them through the loops or through the buckles securing the straps to the vest. Lap belts are attached
to the beam at the back of the backrest (Fig. 12). Adjusting the length of the belts is done by pulling the straps through the
loops.
Fig.
12 Fixing and adjusting the vest and lap belts
NOTE:
Before starting the verticalization process, ensure that all the straps are assembled accurately in the
belt loops, and that all the clampers of the vest and pelvic belts are tighten rightly.
5.
Repositioning manual
The BAFFIN Multifunctional device is equipped with a remote, which allows you to easily change the position of the seat. The
device allows tilting from a recumbent position
.
Before first use, remote control should be plugged into central socket (fig.22).
NOTE:
Before tilting, make sure all straps are properly secured in the mounting loops and all buckles of the
vest and lap belts are properly fastened.
NOTE:
Do not start tilting until all adjustment have been finished. See section 4.
Make sure all securing and adjustment screws are properly tightened.
Do not change the position from recumbent to sitting (or vice versa) with the kneepad in place.
Before tilting, do the following:
1) prior to moving from the sitting to recumbent position (or vice versa), make sure that the kneepad is
removed (see sec. 4.4)
2) install the chest belt and fasten all clamps on it so the user is safely secured to the device.
3) install and fasten the thigh straps
4) lock the wheel brakes
5) remove all items from the table