LIVARNO LUX 3571-096L, Assembly, Operating And Safety Instructions

Page: 40 / 44

41 GB
Preparation / Installation / Start-up Start-up / Cleaning
Switching the luminaire on / off
You have the possibility of operating the luminaire
from an ordinary wall switch or switching it on and
off using the supplied remote control unit.
Switching the luminaire on / off using the
remote control unit:
– The wall switch is in the basic position (OFF).
Activate the wall switch (ON).
Press the ON button on the remote control
16
to
switch the light on (Halogen light bulb and LED).
Push the OFF button on the remote control
16
to
switch the light completely off.
Switching the light on / off with the wall
switch
The wall switch is in the basic position (OFF).
Activate the wall switch (ON). The halogen light
bulbs are on.
Activate the wall switch within approx. 1 second
by repeatedly pushing off and on. The following
switch settings are cycled (halogen light bulb,
LED light bulb, halogen and LED light bulb).
The light can be switched off with the wall switch
or the remote control
16
.
Remote control functions
ON / OFF Halogen light bulb and LED on or off
End colour change / colour selection
Colour
Change
Slow colour change LED:
Press 1 x = Direction of rotation left
Press 2 x = Direction of rotation right
rapid colour change LED:
Press 3 x = Direction of rotation left
Press 4 x = Direction of rotation right
Press 5 x = flowing colour change LED
Lamp Halogen light bulb on or off
Colour
Selection
Press 1 x: LED blue
Press 2 x: LED green
Press 3 x: LED red
Press 4 x: LED green / blue
Press 5 x: LED green / red
Press 6 x: LED red / blue
Press 7 x: LED green / red / blue
Troubleshooting:
If the remote control
16
does not respond after
switching the light on, first press the wall switch to
switch the light off. Then wait approx. 15–20 sec-
onds and activate the wall switch again.
If after switching on the luminaire again via the
remote control unit
16
the luminaire still does not
respond, check the batteries in the remote control
unit
16
.
Changing the bulb
RISK OF ELECTRIC SHOCK!
To replace the bulb, first disconnect the light
from the mains circuit. To do so, remove the
fuse or switch off the circuit breaker in the fuse
box (0 position).
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES!
Allow the light to cool completely.
Replace the bulb
10
only after it has fully cooled.
Use a clean, lint-free cloth to replace the light
bulb.
Carefully remove the defective light bulb
10
from the socket.
Only use the halogen light bulbs specified in
the chapter "Technical Data".
Carefully install the new light bulb
10
into the
socket. Ensure that it is positioned correctly.
Reinstall the fuse or switch on the circuit breaker.
Cleaning
RISK OF ELECTRIC SHOCK!
Disconnect the light from the mains circuit before
cleaning. To do so, remove the fuse or switch off
the circuit breaker in the fuse box (0 position).
Only clean with a dry, lint-free cloth. Do not
use solvents, spirit or similar substances. They
could damage the light.
Allow the light to cool off completely.