LIVARNO LUX 3571-096L, Assembly, Operating And Safety Instructions

Page: 39 / 44

40 GB
Preparation / Installation / Start-up
- Pencil / making tool
- Voltage tester
- Screwdriver
- Electric drill
- Bit (approx. ø 8 mm)
- Side cutting pliers
- Ladder
Prior to installation
Important: The electrical connection must be
established by a trained electrician or a person
trained to perform electrical connections. This per-
son must be familiar with the properties of the light
and the connection regulations.
Familiarise yourself with all the instructions and
diagrams in this manual, as well as with the light
itself, before you install it.
Before installation ensure that the circuit, to which
the light will be connected, is not energised. To
do so, remove the fuse or switch off the circuit
breaker in the fuse box (0 position).
Verify the installation site is suitable to bear the
weight of the light before installation.
Use the voltage tester to verify the de-energised
status.
Installation
Mounting the light
Prior to installation, remove the fuse or switch
off the circuit breaker (0 setting) in the fuse box.
Remove the screws
4
visible at the side of the
connection housing
2
and remove the mount-
ing bracket
1
at the back.
Use the slotted holes intended for the mounting
bracket
1
to mark the bores.
Now drill the fixing holes (approx. ø 8 mm,
depth approx. 40 mm). Ensure that you do not
damage the supply line.
Insert the rawlplugs
3
into the holes. Fasten
the mounting bracket
1
with the provided
screws
5
.
Open the plastic housing
12
. Then feed the
mains connection cable (external)
14
through
the protective tube
13
on the plastic housing
12
.
Now connect the connection cable of the light
to the mains connection cable (external)
14
us-
ing the terminal block
15
. Be sure to correctly
connect the individual wires of the mains con-
nection cable (external)
14
: live wire, black or
brown = symbol L, neutral wire, blue = symbol N).
Close the plastic housing
12
.
Use the screws
4
to fasten the luminaire to
the mounting bracket
1
.
Remove the nuts
8
and plastic rings
7
from
the lamp bulb sockets
11
.
Attach a lamp shade
6
onto each bulb
socket
11
.
Secure the lamp shades
6
with the plastic
rings
7
and the nuts
8
using the tool.
Use a clean, lint-free cloth when inserting the
light bulb
10
.
Carefully insert the light bulb
10
into the socket.
Verify it is seated correctly.
Reinsert the fuse or switch the circuit breaker
back on.
Your light is now ready to use.
Start-up
Inserting / replacing
batteries (remote control)
Open the battery compartment at the back of
the remote control
16
.
Remove the spent battery, if necessary.
Insert a new battery in the battery compartment.
Only use batteries specified in the chapter
“Technical Data“.
Note: Be sure to correctly insert the batteries
(polarity). This is indicated inside the battery
cover.
Close the battery compartment of the remote
control
16
.
Start-up / Cleaning