18 GB/IE
The included mounting material is suitable for ordinary solid concrete or masonry
construction. Check which mounting material is suitable for your chosen mount-
ing surface. If necessary, seek expert advice.
Installation
Make sure you will not be drilling into electrical, gas or water lines inside the wall.
Use a power drill to drill the holes into the brick wall. Always observe all safety in-
structions for the power drill in the manual for the power drill. Death or injury due
to electric shock may otherwise result.
When selecting the mounting location, pay attention to the following:
Make sure that the product illuminates the desired area.
Make sure the motion sensor
15
covers the desired area. The motion sensor
15
has a maximum coverage range of 8 m, with a coverage angle of about 90 °
(depending on the mounting height – a height of 1.8–2.5 m is ideal) (see fig. I).
Make sure the motion sensor
15
is not illuminated at night by street lighting.
This can influence its functioning.
Remove the lamp shade
1
from the lamp body
2
.
Remove the nuts
5
visible at the front of the wall plate
6
, flat washers
4
and
the silicon washers
3
, and open the connection housing
7
. Then take out the
terminal block
12
from the connection housing
7
for easy installation (see fig. B).
Use the holes in the connection housing
7
, which are intended for the mount-
ing screws
11
, to mark the drill holes (see fig. C). Ensure that you fasten the
connection housing with the arrow facing upwards inside the connection hous-
ing
7
.
Now drill the fixing holes (Dia. approx. 6 mm, depth approx. 40 mm). Ensure
that you do not damage the electrical supply line (see fig. D).
Now place the wall plugs
10
into the drill holes.
Slide the mains connection lead
13
through the membrane
8
.
Fasten the connection housing with the mounting screws
11
which are included
(see fig. E).
Connect the connection cable of the product to the mains connection lead
13
by means of the terminal block
12
(see fig. F).
Also ensure that the colour connection of the wires is correct when connecting
(L = black or brown, N = blue or white).
Now connect the earth wire (green-yellow) to the marked earth terminal
(see fig. F).
Ensure the seal
9
is correctly pasted on the connection housing
7
before at-
tached the wall plate
6
.
Now carefully attach the wall plate
6
over the con-
