9
GB
Safety / Preparation / Preparing the product for use
Do not exert mechanical loads to batteries /
rechargeable batteries.
Risk of leakage of batteries / rechargeable
batteries
Avoid extreme environmental conditions and
temperatures, which could affect batteries /
rechargeable batteries, e.g. radiators / direct
sunlight.
Avoid contact with the skin, eyes and mucous
membranes. In the event of contact with battery
acid, thoroughly flush the affected area with
plenty of clean water and seek immediate
medical attention.
WEAR PROTECTIVE GLOVES!
Leaked or damaged batteries / rechargeable
batteries can cause burns on contact with the
skin. Wear suitable protective gloves at all
times if such an event occurs.
In the event of a leakage of batteries / recharge-
able batteries, immediately remove them from
the product to prevent damage.
Only use the same type of batteries / rechargeable
batteries. Do not mix used and new batteries /
rechargeable batteries.
Remove the batteries / rechargeable batteries if
the product will not be used for a longer period.
Risk of damage of the product
Only use the specified type of battery /
rechargeable battery!
Insert batteries / rechargeable batteries accord-
ing to polarity marks (+) and (-) on the battery /
rechargeable battery and the product.
Clean the contacts on the battery / rechargeable
battery and in the battery compartment before
inserting!
Remove exhausted batteries / rechargeable
batteries from the product immediately.
Preparation
Required tools and material
The tools and materials specified are not included.
This information and values specified are non-binding
and are only provided as a reference. The nature
of the material is determined by the individual local
conditions.
- Screwdriver
Preparing the product for use
Assembling the lamp
Note:
You will require a second person to help
with the assembly of the product.
Note:
Place the floodlight on a soft surface
(i.e. a blanket) during assembly to prevent it from
being damaged.
Note:
Please ensure that you pull the cable slowly
through the base during fitting.
Remove the transport locks
15
from the tube
7
.
Connect the sections of tube
7
and screw in
place.
Note:
Be sure to screw in the section of tube
7
as far in as possible to ensure the light is stable.
Be sure not to pinch the mains lead running
through the tube
7
.
Screw the tube
7
to the base
11
.
Tighten the nut
12
at the underside of the base
11
if it has become loose.
Note:
Be sure to hold the tube
7
tight when
tightening the nut
12
.
Note:
Ensure the cable is inside the designated
opening in the base
11
so it cannot be pinched.
Position the uplight upright.
Place the lamp glass
3
on the uplighter head
4
.
Affix the lamp glass
3
using the screws
1
and washers
2
to the uplighter head
4
(see
Fig. A).
Mount the bracket
9
using the two screws
10
to the tube
7
(see Fig. B).
Safety