10 GB
Disposal / Warranty and Service
Preparing the product for use / Care and cleaning / Disposal
Plug the mains plug
14
into a socket that has
been professionally installed.
Your light is now ready for operation.
Inserting / replacing batteries
Slide the battery compartment out of the
remote control
8
.
Insert the batteries included in the scope of
delivery into the remote control
8
.
Only use batteries specified in the chapter
„Technical Data“.
Note:
The correct polarity is indicated on the
reverse side of the remote control
8
.
Slide the battery compartment back into the
remote control
8
.
If the range of the remote control
8
reduces,
the battery needs to be replaced.
Slide the battery compartment out of the remote
control.
Remove the batteries.
Insert new batteries. Proceed as described
above.
Switching the light on / off
Use the ON / OFF switch
17
to switch the
uplighter floor lamp on or off.
By repeatedly pressing the lamp on and off
you can set the colour temperature of the lamp
in stages.
Switch the reading light
5
on or off using the
ON / OFF switch
16
.
Controlling the uplight head
4
using the
remote control
8
:
Switch the uplight head
4
on using the ON /
OFF switch
17
.
Ensure that there are no obstacles between the
lamp and the remote control
8
.
If the lamp has been switched off for longer
than 1 minute, it will switch on at a medium
colour temperature.
Choose from the following functions:
Switch on the uplighter
Switch off the uplighter
Select cold, neutral or warm white
light
brighten
dim
Nightlight function: Using the programme
button, the floodlight illuminates at a
very low warm white dimming level.
The lamp switches off automatically
after 30 minutes.
Switch between cold, neutral and
warm light by pressing the button
Directing the lamp
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES!
First allow the lamp to cool completely.
Bend the flexible arm
6
to bring the reading
lamp into the desired position.
Adjust the uplight head
4
to the desired
position.
Care and cleaning
RISK OF ELECTRIC SHOCK!
First pull the mains plug
14
out of the mains socket.
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES!
First allow the lamp to cool completely.
RISK OF ELECTRIC SHOCK!
For electrical safety reasons, never clean the lamp
with water or other fluids nor immerse it in water.
Do not use any solvents, petrol or similar. This
would cause damage to the light.
Always use a dry, fluff-free cloth for cleaning.
Plug the mains plug
14
into the socket again.