![background image](http://html1.mh-extra.com/html/little-wonder/e-system/e-system_owners-manual-and-safety-instructions_1929718009.webp)
8
Maintenance
Area
Maintenance procedure
Frequency
Spline male/female connection of the
inner drive shaft
Inspect/lubricate
1. Remove centre screw, and loosen up
other two as shown on the diagram
(left).
2. Pull the shaft from the gear housing.
3. Pull and clean internal shaft.
4. Lubricate.
5. Re-install the drive shaft.
20-25 hrs
Gear case
Inspect/clean debris
Remove plug and check level of grease.
Add grease. Do not overfill!
Use EP2 lithium grease
45-50 hrs
Screws/nuts/bolts
Inspect/tighten/replace
Before each use
Remove
Loosen
Pull
Lubricate
Gear case plug
Area
Maintenance
Before
Every 25 Every 50 Every 100
Note
Use
hours
hours
hours
Cutting parts
Replace if
something is wrong
Screws, nuts
Tighten, replace
Not adjusting
bolts
screws
IMPORTANT:
Time intervals shown are maximum. Actual use and your experience will determine the frequency of
required maintenance.