![background image](http://html1.mh-extra.com/html/little-wonder/brc-24-hydro/brc-24-hydro_operators-manual_1929686020.webp)
20
BRUSH CUTTER
ADJUSTMENTS
FREE WHEEL ADJUSTMENT
Stop the engine and remove the spark plug wire
before making any belt adjustments.
1. Plunger setscrew
A
: Tighten the Ball to contact
with the flat on the plunger shaft
C
, then back off
1/4 turn and tighten the jam nut
B
. The plunger
shaft C should move between the drive and free
wheel positions and “snap” into a detent at each
end of the travel.
2. Knob
D
: Position the jam nut
B
and knob on the
plunger shaft so full travel between Free Wheel
and Drive position can be obtained.
3. Connecting Link
E
: Position the knob
D
in the drive
position. Install the swivel F in the hole on the Free
Wheel Valve lever on the transaxle. Push the lever
on the transaxle forward until resistance is felt.
Turn the connecting link rod E into the swivel until it
just goes into the hole in the plunger shaft. Secure
with hairpin cotters
G
at the swivel and rod ends.
4. With the Free Wheel linkage disconnected, the
machine should move only with difficulty. With the
Free Wheel linkage connected, the machine should
roll relatively freely in the Free Wheel Position. In
the drive position it should act the same as when it
is not connected. The rod may need to be turned
in or out of the swivel by a turn or two for final
adjustment.
D
A
B
C
D
E
F
G
Summary of Contents for BRC-24 HYDRO
Page 26: ...26 BRUSH CUTTER...