Little Wonder BRC-24 HYDRO, Operator'S Manual

Page: 11 / 34

11
BRUSH CUTTER
CONTROLS
BLADE CONTROL LEVER (A)
Hold down the lever to engage the blades for cutting.
Release the lever to disengage and stop the blades.
TRACTION CONTROL LEVER (B)
Push the thumb lever down to go in the reverse
direction. Pushing the lever further increases reverse
speed.
Pull the bottom lever up to move in the forward
direction. Pulling the lever further increases forward
speed to the maximum set by the Speed Adjustment
Knob.
SPEED ADJUSTMENT KNOB (C)
Turn the knob clockwise to decrease maximum speed.
Turn the knob counterclockwise to increase maximum
speed.
FREE WHEEL KNOB (D)
Push the knob in to freewheel the machine.
Pull the knob out to engage the transmission.
THROTTLE CONTROL (E)
Control the engine speed. Pushing the lever forward
makes the engine speed go faster, while pulling the
lever back slows down the speed of the engine.
ENGINE STARTER CORD (F)
Pull the cord to turn the engine over to start it. See
section and/or operation.
PARK BRAKE (G)
Pull lever up to engage the park brake.
Push lever down to disengage park brake.
FUEL VALVE (H)
Move to the “OFF” position to shut off the fuel
whenever transporting the machine by trailer or truck
or during storage. Move to the “ON” position before
starting the engine.
SET-UP INSTRUCTIONS / CONTROLS
SET-UP INSTRUCTIONS
1. Unpack the unit.
2. Open the free wheel valve by pushing the free wheel knob on the back of the machine. Roll the machine off of the
pallet.
3. Connect the blade control linkage.
4.
Fill the engine with the proper grade of oil. See engine manual for oil specifications.
5. Read the operation and safety manual before starting. The operator manual is located in the tube on the front of the
handle support.
6. Run the engine for 5 minutes before engaging the blades to ensure full lubrication.