7
ENG
USE OF THE DEVICE WITH THE POWER SOURCE
The manufacturer recommends application of the stabilized power source
LD-N057 (it is attached to modifi cation LD51A и LD51U). The jack for connection
of the power source is on the right side of the Device.
To use the device with electric power source (EPS), connect plug connector of
EPS to the Device and insert plug of EPS into mains socket, press .
Measurement over, switch off the Device having depressed button кнопку
, remove plug of EPS from mains socket and disconnect plug connector from
the Device. To avoid resetting of date and time, do not remove the batteries
when using the device with power cells.
SETTING OF DATE AND TIME
1. To shift to mode of date and time setting, it is necessary to press and hold
for over 5 seconds.
2. If mode of date and time setting is switch on, to set date and time it is
necessary, holding M1, depress button .Parameter will blink. Change of
selected parameter toward increasing is taking place when depressing button
M2, towards decreasing – when depressing button M1. To shift to setting of
the next parameter, year/month/hours/min, it is necessary to depress
.
3. If no actions are done in mode of date and time setting for more than 1
minute, the Device is independently changed over to mode of date and time
indication. In this case, all the changes that have been already made will
come into eff ect.
4. To switch off mode of date and time setting, it is necessary to press and
hold for over 5 seconds.
1. Sit at a table so that during blood pressure
measurement your hand rests on its surface. Be sure
that the cuff is placed approximately at the level of
your heart and that your arm lies freely on the table
and does not move.
After replacing the batteries the mode of date and time indication is always off .
The factory setting of the clock mode is OFF.
When power cells are replaced, date and time will zero, and measurement
results will be safe without date and time setting.
If the device does not take measurements while the date and time indication
mode is ON, the display will show current date and time.
CORRECT POSITION DURING MEASUREMENT
Fig.4
