7
ENG
The jack for connection of the power source is on the right side of the Device.
To use the device with electric power source (EPS), connect plug connector
of EPS to the device and insert plug of EPS into mains socket. .
Measurement over, switch off the device having depressed button, remove
plug of EPS from mains socket and disconnect plug connector from the
device. To avoid resetting of date and time settings when using the device
with electric power source, do not remove power cells.
CORRECT POSITION DURING MEASUREMENT
1. Sit at a table so that during blood pressure
measurement your hand rests on its surface.
Be sure that the cuff is placed approximately
at the level of your heart and that your arm
lies freely on the table and does not move.
2. You can measure the blood pressure lying on
the back. Look at the ceiling, keep quiet and
do not move during measurement. Be sure
that the cuff is placed approximately at the
level of your heart.
CUFF PREPARATION
1. Insert the cuff end for about 5 cm into a metal ring.
2. Apply the cuff to your left upper arm so that the air
tube is directed to your palm. If the measurement on
your left arm is dif
fi
cult, you may use your right arm.
In this case remember that the readings may differ by
5-10 mmHg and even more.
3. Wrap the cuff around your upper arm so that the
bottom of the cuff is approximately 2-3 cm above
your elbow. The sign “ARTERY” should be over the
arm artery.
4. Fix the cuff so that it
fi
ts tightly to the arm, but see
that it is not overtight. Too tight or too free placement of
the cuff may give inaccurate readings.
5. On the
fi
xed cuff the sign “index” should point to
the area “normal (25-36 cm)”. it means that the cuff is
chosen correctly and
fi
ts the size of your upper arm.
if the sign points to the area marked «
», the cuff
is too small and the readings will be higher. If the sign
points to the area marked «
», the cuff is too large
and the readings will be lower.
