EN
Page 17
Motor part becomes warm
Air filter is blocked; air can no
longer circulate
Remove air filter and clean
with brush or replace filter
Shearing tension too high
clipping
Do not tighten pressure tensi-
on nut so much.
If the blades still do not cut,
they should be resharpened
or
replaced
Motor bearing defective
Have the motor replaced
Broken fan
Have it repaired by service
centre
Motor vibrates
Bearings are worn out
Have the motor replaced
Motor has a very loud noise
Seized bearings
Have it repaired by service
centre
6.
Others
6.1.
Environmental Protection and Disposal
The owner has a duty to dispose of the clipper blades as well as of the clipping machine proper-
ly at the end of its service life. Please observe your relevant national regulations.
6.2.
Declaration of conformity
This device complies with the requirements of the following EU directives:
2004/108/EG
2006/95/EG
Summary of Contents for 1400-10
Page 90: ......