37
provided for use with the equipment.
If the battery pack is very hot you must remove
your battery pack from the charger and allow time
for the battery to cool down before recharging.
Please charge the battery to reach full before
storage. If the tool will not be used for long periods
of time, charge the battery every 3 months.
C1
red
light
green
light
C2
CHARGING PROCEDURE
1) Plug the charger into an appropriate outlet.
The light will be green.
2) Slide the battery pack into the charger, make
sure the battery is in the correct charge
position firmly. the light will turn to red to
indicate the charging process has started.
3) When charging is completed, the light will turn
to green.
4) After fully charged, unplug the charger and
remove the battery pack.
NOTE: If the battery pack is locked in the
charger, press the battery pack release button
and remove it.
WARNING:
When battery charge runs
out after continuously use or exposure to
direct sunlight or heat, allow time for the tool to
cool down before re-charging to achieve the full
charge.
Charging indicator
This charger is designed to detect some problems
that can arise with battery packs. Indicator
lights indicate problems (see table below). If this
occurs, insert a new battery pack to determine
if the charger is OK. If the new battery charges
correctly, then the original pack is defective and
should be returned to a service center or recycling
service center.
If the new battery pack displays the same problem
as the original Battery Pack, have the charger
tested at an authorized service center.
Light
ON/OFF flash
Status
Red on
Charging
Red flash
- - - -
Defective
Battery
Green on
Fully Charged
Green flash
- - - -
Hot/Cold
Delay
The battery chargers and the battery packs
illustrated or described above are not included in
the delivery.
2. TO REMOVE OR INSTALL BATTERY PACK
(SEE FIG. D1, D2)
Depress the Battery Pack Release Button to
remove the Battery Pack from your tool. After
recharging, insert the Battery Pack into the battery
port. A simple push and slight pressure will be
sufficient until a click is heard. Check to see if the
battery is fully secured.
D1
D2
