39
5. TO MANUALLY FEED THE LINE (SEE FIG. H)
Press and release manual line feed button, whilst
gently pull out the lines until the lines reaches the
line cutter.
If the line extends past the line cutter, too much
line has been fed out.
If too much line is fed out, remove the spool
cover and rotate the spool anti-clockwise
until the line is at the desired length.
H
14
5. TO REMOVE THE CAP (SEE FIG. I)
Press and hold in the two latches. Pull cap away
from the spool base. When refitting the spool cap.
Keep all areas of the cap and spool base clean.
Replace the cap, pressing firmly down towards the
spool holder to ensure cap is fully located. Check
that the cap is correctly fitted by trying to remove it
without depressing the two latches.
I
6. TO CHANGING THE SPOOL (SEE FIG. J)
NOTE: For your convenience it is
recommended you buy replacement spools
with the trimmer line preinstalled.
Remove Spool Cap Cover. Remove the old Spool
from spool base. Clear any broken line or cutting
debris from the spool area. Pull the line from the
new replacement Spool through the eyelet of the
Spool base. Place new spool into the spool base
with the cut out areas of the spool facing inward
or down. When installed into the Spool base,
the smooth side of the spool should be visible.
Release line from cleat on the spool. Refit the
Spool Cap Cover.
J
TO MANUALLY WIND LINE (SEE FIG K1-K3)
IMPORTANT!
Your trimmer is designed to use only
line with a maximum diameter of 1.65mm.
Take approximately 3m of line. Insert 15mm of line
into the spool holes and wind line in the direction of
the arrows on the top of the spool. (See Fig. K1, K2)
Leave approximately 100mm of line unwound and
place it into the cleat. Care should be taken to ensure
that the line is neatly coiled on the spool. (See Fig.
K3) Failure to do so will impair the efficiency of the
automatic line feed. Then fit the spool as described
above in “To changing the Spool”.
K1
K2
K3
