Lissmac SBM-XS 300 G1E1 ALU MIX, Operating Manual, Page: 35 / 53

Changing abrasives
Grinding machine SBM-XS 300 G1E1 ALU MIX 35
6.1.1 Replacing E-unit grinding mop wheels
Changing the grinding belt is shown on the upper E-unit. Changing the grinding
mop wheels in the lower E-unit is identical.
The upper and lower E-units must be moved to a material thickness of "15 mm"
to change the grinding mop wheels (see 5.2.3).
Fig. 18: E-unit with tool cover
1 Tool cover
2 Screw fasteners
3 Screw fasteners

Remove the fastening screws (2 and 3).

Remove the tool cover (1).
Fig. 19: E-unit without tool cover
4 Clamping nut

Remove the clamping nut (4) and spring washer.

Remove worn grinding mop wheels from the fixture shaft.
Only use original grinding media from the manufacturer!

Insert new grinding mop sheels onto the fixture shaft, check the running
direction during this!

Mount the clamping nut (4) and tighten (25 Nm).

Fasten the tool cover (1) with the fastening screws (2 and 3).

Set the E-unit (see Chapter 6.2.2).
4
2
3
1