19
5.6 Change from right to left cut
The waste water suction (Pos. 32) must be removed (see
5.8.4)
Remove the protective hood and saw blade (see 3.3)
Remove the safety cover (Pos. 50.5) on the saw blade
shaft
Mount the saw blade (see 3.3)
Replace the saw blade protective hood
Mount the water supply (Pos. 6)
Turn the steering rod (Pos. 4)
* Swing the steering wheel out
(only MULTICUT 800 GH)
* Mount the feed lever (Pos. 20) to the adapter (Pos. 36)
(only MULTICUT 800 GH)
Mount the waste water suction (Pos. 32) on the floor cutter
(see 5.8.4).
5.7 Changing the saw blade speed (also see 6.9)
Standard speed is 1550 1/min v-belt (Pos. 58.4)
Remove the guard plate (Pos. 50)
Disconnect water supply (only for MULTICUT 800 GH
and GH or accessories) on the saw blade shaft
Loosen screws (Pos. 57) (left and right)
Release the tension on the V-belts using screw pos. 58
(left and right)
Loosen and remove nuts (Pos. 58.1) and fold clamps
(Pos. 58.3) down
Fold up both holders (Pos. 58.2)
Set down the saw blade shaft into the holders (Pos. 58.2)
Remove V-belts (Pos. 58.4)
Install additionally delivered V-belts in pos. 58.5 (speed
970 1/min)
Installation of the saw blade shaft in reverse order
Attention!
Tension the V-belt equally - follow the scale (Pos. 58.6) on
both sides.
5.8 Setting the steering suspension (Pos. 25)
Using only one-sided cutting resistance it is not possible to
operate the joint cutter in a straight line without steering in the
opposite direction. When you have reached the proper
opposite steering amount, the steering can be set using the
lever (Pos. 25).
