15
3.2 Connections and operating materials
The joint cutter is delivered filled with diesel fuel,
however this should be checked (see also 6.1.
Maintenance
All lubrication points are lubricated with Roxana ALU
EP2
HD system (Pos. 48)
Filling hole for diesel (Pos. 62)
Connect cooling water hose
3.3 Install saw blade
Danger!
Risk of injury!
Saw blade exchange may only be done with a shut down
motor (Pos. 21) and when the saw blade is at a standstill.
Switch on ignition (Pos. 21) but do not start the motor
Move the saw blade drive to the highest position using
the lever (Pos. 19).
Shut off the ignition (Pos. 21)
Disconnect the water hose
Remove exhaust hose (Pos 26)
(only MULTICUT 800 GH)
Unscrew the ring screw (Pos. 27) and remove the Y-
piece from the holder
Unscrew the M 10 (Pos. 27.1) ring nut
Remove the saw hood (Pos. 5)
Loosen the hexagon head screw (left-hand thread)
Remove the pressure disc
Insert the saw blade
Attention!
Ensure that the flange surfaces are clean.
Match the direction of rotation of the saw blade (arrow on the
blade) with the arrow on the saw hood (synchronised sawing).
Mount the pressure disc and fasten using the screws
(use force to tighten)
Replace the protective hood
Mount the ring screw (Pos. 27.1)
Place the Y hose piece into the holder and tighten it with
the ring screw (Pos. 27)
Mount the exhaust hose (Pos. 26)
(only MULTICUT 800 GH)
Connect the water hose
