Rev: 06.30.22
Page 11
CCD-0001575
Upper Trolley Tab Rotation
Resources Required
• Phillips head screwdriver
The upper trolley tabs can be rotated to change the amount of space between the bed platform and the
upper bunk stop.
NOTE:
If the upper bunk is in a locked position, see Automatic Upper Bunk Lock System for instructions on
releasing the bunk lock.
1.
Press the DOWN switch to lower the upper bunk.
2.
Remove the bunk platform by following the steps below:
A.
Remove the hairpin (Fig. 18A) securing the clevis pin (Fig. 18B) and washer (Fig. 18C).
B.
Remove the clevis pin holding the bedlift rail (Fig. 18D) to the tab bracket (Fig. 18E).
C.
Repeat for the other side.
3.
Carefully remove the bed platform (two people required).
D
B
E
C
A
5.
Remove the cap from the cranking point (Fig. 17A) on the non-motor side of the bedlift.
Fig. 17
A
Fig. 18
Motor
6.
Using a 1/2" socket wrench, incrementally crank the bed lift on the non-motor side.
7.
After each crank, measure as outlined in step 2. Continue to crank until the desired level is reached,
then apply the brake.
8.
Plug the motor harness into the relay module.
9.
Replace the cap removed in step 5.
