8
lci1.com
574-537-8900
Rev: 04.03.20
Solera
®
Universal Hardware
Power Awning to
Solera 12V Power Awning
(For Aftermarket Application)
CCD-0001282
16.
Secure the upper section of the drive side mount
arm to the unit with 2 of the provided #14 x 1
1/4
” screws
(Fig.10)
.
NOTE:
Silicone sealant
MUST
be used on all screws and
holes to prevent water from infiltrating the unit.
NOTE:
Do
NOT
install fasteners to the lower and middle
sections of the wall mount arm at this time.
17.
Repeat Steps 7-16 for the idler side support
arm assembly.
18.
Cut the nylon ties containing the support
arm assemblies.
19.
At the drive side support arm assembly, connect the
motor leads
(Fig.11A)
to a cordless battery
(Fig.11B)
and
fully extend the awning.
20.
Remove the wire covers to expose the lower and middle
sections of the mount arm.
NOTE:
If the power leads exiting the unit do not align with
the hole in the wall mount arm, a new hole must be drilled
out on the wall mount arm
PRIOR
to securing the lower and
middle sections of the arm so as not to damage the unit.
21.
Secure the lower
(Fig.12)
and middle
(Fig.13)
sections
of the drive side mount arm to the unit using the provided
#14 x 1
1/4
” screws or rivets.(There will be 2 screws in the
lower holes and 2 in the middle holes).
NOTE:
Silicone sealant
MUST
be used on all screws and
holes to prevent water from infiltrating the unit.
NOTE:
For units with fiberglass sidewalls, LCI requires the
use of rivets for securing the lower and middle sections of
the mount arm.
Fig.10
A
B
Fig.11
Fig.12
Fig.13
22.
Repeat Steps 20-21 for the idler side mount arm.
NOTE:
See “Wiring” Section to complete installation.
23.
Replace wire covers after wiring is complete.