8. Pedal Installation
(POTENTIAL FOR DAMAGE IF
INSTALLED INCORRECTLY!)
8.1
Pedals are side-specific. Check the
ends of the axles to identify which side of
the bicycle to install them in. R = Side of
bicycle with chain.
Apply a small amount of grease to the
pedal threads.
8.2
Install the pedal marked R by turning
the axle CLOCKWISE.
Install the pedal marked L turning the
axle ANTI-CLOCKWISE.
Tighten the pedal axles fully with the
15mm wrench.
Torque Requirement:
28-37Nm.
9. Seat Post Installation
9.1
Apply a small amount of grease around
the bottom 1.5” (35mm) of the seat post
(A)
and insert the seat post into the seat tube.
Insert seat post so that the minimum
insertion line
(B)
is not visible and align
the saddle with the bicycle’s top tube.
Tighten down the seat post clamp
(C)
using the appropriate hex wrench.
Torque Requirement: 4.5-6Nm.
9.2
Check to make sure that the
saddle is level
(D)
. If it is not, use a 6mm
wrench to loosen the saddle clamp,
adjust the saddle, and re-tighten.
Torque Requirement: 20-27Nm
.
10. 3-Speed Hub/Shifter
Adjustment
10.1
Twist the shifter
(A)
into the middle
position (2nd gear) on the handle bar.
10.2
Look at the shifter box on the chain
side of the rear wheel. A yellow indicator
line should align with two arrows.
10.3
If the hub is out of adjustment
unthread the black lock-nut
(B)
1-2
turns with a multi-size wrench.
10.4
To move the indicator line toward
the bicycle, turn the barrel adjuster
(C)
anti-clockwise. To move the indicator
away from the bicycle, turn the barrel
adjuster clockwise.
Once the indicator line is between the two
vertical lines, tighten the lock-nut down.
A
B
C
10.1
10.2
8.2
8.1
10.3
9.1
10.4
9.2
B
A
C
A
0°
D
(SIDE-SPECIFIC THREADING ON PEDALS)
7
