5
Chapter 2: Getting to Know the Switch
SRW208G - Front Panel
WebView Switches
Ports
1-8
The Switch is equipped with 8 auto-sensing, Ethernet network ports, which use RJ-45
connectors. The Fast Ethernet ports support network speeds of 10Mbps or 100Mbps.
They can operate in half and full-duplex modes. Auto-sensing technology enables each
port to automatically detect the speed of the device connected to it (10Mbps or 100Mbps),
and adjust its speed and duplex accordingly.
Console
The Console port is where you can connect a serial cable to a PC’s serial port for
configuration using your PC’s HyperTerminal program. Refer to
Chapter 4: Using the
Console Interface for Configuration
for more information.
SRW208G - Front Panel
The Switch's LEDs and ports are located on the front panel.
LEDs
System
Green.
The
SYSTEM
LED lights up to indicate that the Switch is powered on.
Link/Act
Green.
The
LINK/ACT
LED lights up to indicate a functional network link through the
corresponding port (1 through 8, G1, or G2) with an attached device. It flashes to indicate
that the Switch is actively sending or receiving data over that port.
100M
Orange. The
100M
LED lights up to indicate a 100Mbps connection on the corresponding
port (1 through 8).
Gigabit
Orange. The
Gigabit
LED lights up to indicate a Gigabit connection on the corresponding
RJ-45 port (G1) or miniGBIC port (G2).
Figure 2-2: Front Panel of the SRW208G
Summary of Contents for SRW208G
Page 6: ...WebView Switches Appendix G Regulatory Information 125 Appendix H Contact Information 131 ...
Page 138: ...127 Appendix G Regulatory Information WebView Switches ...
Page 139: ...128 Appendix G Regulatory Information WebView Switches ...
Page 140: ...129 Appendix G Regulatory Information WebView Switches ...
