Linkcom France
11 rue du Soleil Levant 92140 CLAMART Copyright © 2008 – Linkcom – Tous droit réservés
3
1. Technical parameters
- Dimensions
133 x 233 x 60 mm
-
Weight 850
g
- Operating position
various
- Operating condition
temperature: +5°C ÷ +40° C
Humidity: 10% ÷ 80% p
i 30° C
- Power supply
9-15V ss or 8-12Vst, 1.5 A
VoIP
•
Ethernet – 10/100Mb with standard BaseT and 100BaseTx, connector RJ45
•
SIP connection: P2P or IPPBX SIP server – tested with Cisco Call Manager, Alcatel OMNI PCX, Asterisk,
Nexspan, Panasonic…
•
2 VoIP channels (2 IP addresses)
•
Codec audio : G711u, G711a, G726, GSM
•
VAD (Echo cancellation)
•
Protocols: IP, TCP, UDP, http, TELNET, SIP, RTP
•
Web server for remote management
•
WEB – firmware upgrade
•
Remote connection with DTMF dial in
•
connection to 2
nd
operators after time out (adjustable) for direct dialling in
•
Caller Id number (CLIP)
•
incoming call restriction from GSM network
•
outgoing call restriction to GSM network
•
Priority connection through either the 1
st
or the 2
nd
GSM module (LCR)
•
Smart Call back – automatic incoming calls routing up CLIP
•
Direct access – assign of IP address to GSM channels
•
Echo canceller – switching ON/OFF
•
OGM* Option module for recording DISA voice message*
•
PIN SIM card protection
GSM
•
GSM 900 (class 4 – 2 W)
•
GSM 1800 (class 1 – 1 W)
•
Antenna connector SME/SMA, 50
•
SIM card: 3/1,8 V
•
2 GSM channels
2. Setting operational Mode (P2P or SIP Server)
The Link Gate SIP can be configured in 2 different modes: P2P or SIP Server.
•
In P2P mode, the Link Gate SIP behaves as a sample GSM gateway. In case of incoming call on the GSM
module, the Link Gate SIP will convert it in SIP and transfer it to the SIP server (IPBX). For an out going call,
the Link Gate SIP process a GSM call when SIP call is receives over IP addresses.
•
In SIP Server mode, the Link Gate SIP acts as a SIP server and allow recording up to 10 IP/SIP phones. It
is also possible to register the Link Gate SIP on an existing IPBX.
P2P Mode
SIP Server Mode
