Linkcom France
11 rue du Soleil Levant 92140 CLAMART Copyright © 2008 – Linkcom – Tous droit réservés
10
7.3 Incoming call setting:
In
SIP SERVER
mode Internal or External you will have to select which extension should ring during an Incoming call. fill this Extension N° in
“GSM 1 Module”
and
“GSM 2 Module”
7.4 Outgoing Call setting:
In
SIP SERVER
Mode (internal), dial the outgoing prefix number set in “
SIP SERVER
” Menu followed by the phone number.
In our Example GSM 1 Module prefix is 7 and GSM 2 Module prefix is 8.
In
SIP SERVER
Mode (External), create in the IPBX 2 Trunk SIP routes pointing on IP 1 and IP 2 of the Link Gate SIP.
8. Description of GSM Parameters
8.1 General GSM parameters
DISA:
Allow callers to dial-in directly the subscriber number from 1 to 4 digits depending on the numbering schema
of the IPBX.
OGM:
The Link gate SIP can be provided with OGM optional Board “DISA messages” for individual GSM channel.
Allowing recording a DISA welcoming message of 16 seconds, inviting callers to dial the subscriber’s number they
want to reach
This message can be recorded through a PC using the special supplied RS 232 interface and the recording software
OGMrec.
Rec:
The new OGM module doesn't use this parameter.
Wait:
when DISA is activated this Time out table allows waiting for caller to dial-in a subscriber number.
If caller do not dial in or exceed the Time out figure the call is automatically rooted to the operator.
Erase Clip:
Allow erasing first Digits of the Incoming call number.
By default “0” mean no number will be delayed. You can erase the area code of an incoming call ex :
+33140831313 will be translated to 140831313.
Modules directly:
By activation this feature you disabled LCR (permitted direction). The IP address 1 is
automatically assigned to SIM 1 card And IP address 2 is assigned to SIM 2 card. The LCR then can be assign
directly in the SIP server.
Echo canceller:
This feature restrict ECHO during transfer between digital and analogue telephone systems.
Add zero before CLIP:
Adds automatically 0 before each incoming number.
Start with module 1:
The Link Gate SIP will start reading LCR in module 1.
