Link TLC-7300UCL, Instruction Manual

Page: 20 / 27

20 / 27
Command Name Format Argument Return value Explanation
Get ID id[?]<CR> Non ID(Default：0) Get the camera ID
*1 This is for multiple camera management
Set ID id=N<CR> N：0～255 OK Set the camera ID
*1 This is for multiple camera management
Get Sync. sync[?]<CR> Non 0：Auto mode Get the Sync system of the camera
1：Ext Sync
2：Int Sync
3：Ext Sync(AntiBlooming)
Set Sync. sync=N<CR> N=0：Auto mode OK Set the Sync system of the camera
N=1：Ext Sync Ext Sync is from CC1.
N=2：Int Sync
N=3：Ext Sync(AntiBlooming)
Get Exposure expc[?]<CR> Non 0:Line period exposure Get the Exposure control status
Control 1:Fixed time exposure
2: Pulse width exposure
Set Exposure expc=N<CR> N=0：Line period exposure OK Set the Exposure control status
Control N=1:Fixed time exposure
N=2: Pulse width exposure
Get Exposure expt[?]<CR> Non 0-255：Exposure time Set the Exposure time
Time explt[?]<CR>
Set Exposure expt=N<CR> N=0-255：Exposure time OK Get the Exposure time
Time explt=N<CR>
Get Gain Position gainpos[?]<CR> Non 1-2：Gain position Get the Gain position
Set Gain Position gainpos=A<CR> A=1-2：Gain position OK Set the Gain position
Get chXgainA chXgainA[?]<CR> X=1-12：ch 0-255：Gain level Get the Gain level of each gain postion of
A=1-2：Gain position each channel
Set chXgainA=N<CR> X=1-12：ch OK Set the Gain level of each gain postion of
chXgainA A=1-2： Gain position each channel
N=0-255： Gain level
Color gap rgb_on=N<CR> 0：OFF OK Color gap control on/off
control 1：ON value setting
on/off rgb_on[?]<CR> Non 0：OFF Color gap control on/off
1：ON value reference
Color gap rgb_dir=N<CR> 0：RGB OK Color gap scan direction
dir 1：BGR value setting
rgb_dir[?]<CR> Non 0：RGB Color gap scan direction
1：BGR value reference
Color gap rgb_ldelay=N<CR> N:0-8 OK Color gap delay lines
line rgb_ld2=N<CR> N:0-16 OK value setting
rgb_ldelay[?]<CR> Non 0-8 Color gap delay lines
rgb_ld2[?]<CR> 0-16 OK value reference
Check check<CR> Non OK Communication test
Save save<CR> Non OK Save settings to the EEPROM
Load load<CR> Non OK Load settings from the EEPROM
Version ver<CR> Non Version Get the version number of the program for
the microcomputer control
Revision rev<CR> Non Revision Get the version number of FPGA
Initialize init<CR> Non OK Load the factory settings
config cfg<CR> Non (Data output) Get the all current settings
*1…ID can be saved on the user area of the EEPROM by the save command. It cannot be cleared by the clear command.
G
a
in
Sy
ste
m
Us
e
r
Sy
n
c
s
e
le
c
ti
on
Exp
os
u
re
c
on
tro
l
Exp
os
u
re
ti
me
Co
lor
G
a
p