13
/
27
7-5 Color gap control
This is the function to correct the color gap by delaying the output timing of two lines (Red
⁒
Green or Green
⁒
Blue).
<Setup steps>
rgb_on = 1 <CR> To enable color gap correction.
0 : OFF 1 : ON
rgb_dir = 0 <CR> To select a direction for correction.
0 : R → G → B
1 : B → G → R
rgb_ldelay = N <CR> To set the correction amount (line numbers) for the second line.
N = 0 to 8
rgb_ld2 = N <CR> To set the correction amount (line numbers) for the third line.
N = 0 to 8
Example: rgb_dir = 0 and the delay amount between adjacent lines
is 2 lines.
rgb_ldelay = 2 & rgb_ld2=4
Red delay lines
: 4 lines
(rgb_ld2)
Green delay line : 2 lines
(rgb_ldelay)
Blue delay lines : 0 line
7-6 Data rate setting
This is the function to switch the video output mode between "80MHz Base Configuration"
and "120MHz Medium Configuration".
<Setup steps>
1. The data rate 80MHz [Base Configuration] mode.
scan_dir = 2
<CR>
speed = 1 <CR>
2. Data rate 120MHz [Medium Configuration] mode
scan_dir = 0 <CR>
speed = 0 <CR>
