Linhai Landboss LH800U-2D, Owner'S/Operator'S Manual

Page: 114 / 121

LH800U-2D(L)/LH800U-2D(R)
OWNER’S/OPERATOR’S MANUAL
14.0
16. MAINTENANCE
16 - 25
3 Clean the machine to remove unwanted material and corrosives.
Remove the grease or petroleum jelly from the ram piston rods, if
applicable.
4 Install a charged battery.
5 Check the tension of the alternator drive belt.
6 Start the engine.
7 Operate the hydraulic controls, if applicable.
Make sure that the hydraulic functions operate
correctly.
STORAGE TIPS
CAUTION
Do not start the engine during the storage period. This will disturb the
protective film created by fogging.
Cleaning
——Clean the UTV thoroughly.
Fuel
——drain the carburetor bowl completely.
Oil Add and Filter Change
——Warm the engine and change oil and
filter.
Air Filter/Air Box
——Inspect and clean or replace the pre-cleaner and
air filter. Clean the air box and drain the sediment tube.
Inspect All Fluid Levels
——Inspect the following fluid levels and
change if necessary: transmission; brake fluid (change every two years
or as required if fluid looks dark or contaminated).
Check and Lubricate Cables/Grease
——Inspect all cables and
lubricate.
Storage Area/Covers
——Set tire pressure and safely support the UTV
with the tires 1-2”(25-50mm) off the ground. Be sure the storage area is
well ventilated. Cover the machine with a UTV cover.
NOTE: Do not use plastic or coated materials. They do not allow
enough ventilation to prevent condensation, and may promote
corrosion and oxidation.