9
Entry System Mounting (Continued)
Recessed Mounting
The cabinet can be mounted recessed using the accessory trim-ring
(P/N ACP00909). The trim-ring mounts in the wall and the cabinet
attaches to the trim-ring.
1. Identify the location of any studs in the wall.
2. Cut a 16-1/4” high by 13-1/4” wide rectangular hole between studs
at the mounting location.
3. Install any additional mounting material required to provide
surfaces inside the wall 13-1/4” apart for attaching the trim-ring.
4. Place the trim-ring in the wall hole. Check for level, then attach the
trim-ring with up to six screws into the side tabs.
5. Drill the cabinet’s four self-drill mounting holes the appropriate size
for the hardware.
6. Attach the cabinet to the trim-ring using self-tapping screws.
7. After routing the wiring into the cabinet, replace the circuit board
mounting plate and plug in the wiring connectors. Be sure to
replace the green ground wire.
Pedestal Mounting
The cabinet can be mounted on a gooseneck pedestal. Linear
manufacturers two pedestals: Model GNC-1 is for surface mounting with
concrete fasteners, Model GNB-1 is for burial mounting. When mounting
to a pedestal, use the cabinet reinforcing plate to stiffen the cabinet.
1. Install the pedestal at the desired location.
2. Place the reinforcing plate
inside
the cabinet.
3. Use security hardware to attach the cabinet and reinforcing plate
to the pedestal.
4. After routing the wiring into the cabinet, replace the circuit board
mounting plate and plug in the wiring connectors. Be sure to
replace the green ground wire
PEDE
S
TAL
ALI
G
N THE
R
EINFO
R
CIN
G
PLATE
ON THE IN
S
IDE OF THE CA
B
INET
U
S
E
S
ECU
R
ITY HA
R
DWA
R
E
TO ATTACH THE PLATE AND
CA
B
INET TO THE PEDE
S
TAL
PEDESTAL
MOUNTING
MA
R
K HOLE LOCATION
4
IN
S
TALL ANY
S
HIM
S
TO
ALLOW MOUNTIN
G
AND
ATTACH THE T
R
IM-
R
IN
G
WITH UP TO 6
S
C
R
EW
S
5
6
D
R
ILL
3
/16" HOLE
S
IN
THE CA
B
INET AT THE
P
R
E-MA
R
KED LOCATION
S
ATTACH THE CA
B
INET TO
THE T
R
IM-
R
IN
G
WITH
S
ELF-TAPIN
G
S
C
R
EW
S
DETE
R
MINE LOCATION FO
R
THE 1
3
-¼" x 16-¼" MOUNTIN
G
HOLE
3
CUT MOUNTIN
G
HOLE
1
2
RECESSED
MOUNTING
16-¼"
13-¼"
