T
emperature setting
Normally, your film supplier should provide the information about the film
application temperatures and operating characteristics. If you do not know the
source of your film, or if the supplier cannot provide the information, please try
the temperature and speed until you have the best result.
COLD LAMINATING
1.Set the HOT / COLD switch to COLD.
2.Set the speed to the required speed.
3.Put the document on the feed table.
4.Set the FWD / REV switch to FWD and set the RUN / STOP switch to RUN.
5.Stop the machine after the document to be laminated pass through the roller
completely, otherwise there will be an imprint on the document.
CAUTION:
The adhesive side must face away from the roller.
GENERAL MAINTENANCE
Do not laminate the metal or other hard items in case the damage of the rubber
rollers.
While stop the laminating, lift the top rubber roller with the knob on the right
side of the machine. Do not press the rubber roller in case the rubber become
stiff and thus shorten its work-life.
Cleaning the machine timely will help prevent dirt or adhesive build-up on the
rubber rollers and will improve the performance of the unit.
CLEANING THE RUBBER ROLLERS
During the normal lamination, excess adhesives from the film will often cling to
the rubber rollers.
To clean the rubber rollers, lift the rubber roller, remove the film from the
machine first, heat up the machine to 30-40 . The warm roller enable it
easier to remove the adhesive built-up on the rollers. Raise the safety shield
and take out the feed table. Using a clean, soft, ethanol dampened cloth,
gently rub the adhesive off the rollers.
CAUTION:
Never use any abrasive or sharp metal material or rub too hard
on the roller, because you may damage the rubber surface.
MAINTENANCE AND SERVICE
10
