CAUTION:
For hot laminating, the top and bottom roll film must have same
width, besides, the top film and bottom film must be aligned. (If the film is not
in alignment, loose the bolt on core adapter and align it.)
Step 4: With both roll films threaded and installed in their respective brackets,
unwind the top and bottom supply rolls about half-turn each. This will provide
enough slack in the web to allow the feed table to slide on easily.
Step 5: Slide the feed table into position and lock the active bolt.
OPERA TION INSTRUCTIONS
7
Step 3: Follow the diagram to thread the film
Remark: Usually the shiny side is the polyester side, it contact the roller.
The dull side is coated with adhesive. For the matte film, the two sides have
minor difference, please especially be careful. Heat the film with lighter can
easily tell the polyester side and adhesive side. The adhesive side must face
away against to the roller.
Slide the roll film onto the roll shaft (follow the above instruction, do not load
the film in wrong side). Hold the roll film on the core adapter, the core adapter
can hold the core of the roll film, to prevent it rotating. Screwing the bolt on the
core adapter. Put the rolls on the brackets. Make sure it is fully seated.
Top roll film
Bottom roll film
Top stabilizer bar
Bottom stabilizer bar
Top heating roller
Bottom heating roller
Top pull roller
Bottom pull roller
Film outsid e top
sta bilizer bar
Top roll film
Top stabilizer bar
Top heating roller
Film inside top
sta bilizer bar
Bottom roll film
Bottom stabilizer bar
Bottom heating roller
Top pull roller
Bottom pull roller
Film Threading Diagram
Tension knob
Spring
Bracket
Friction plate
Bushing
Core adapter
Roll film
Bolt
Bracket
Bushing
Core adapter
Bolt
Tension knob
Friction plate
