Step 3: Insert a piece of wide cardboard (guiding paper) between the rollers. the
width of cardboard should be larger than the width of cold film. Pull the film
from the top roller passing over the top stabilizer bar to the top roller.
Step 4: Put the paper back of the cold film to the bobbin at take-up bar to rewind
the paper back. Allow some of the cold film with melted resin to stick the wide
cardboard (guiding paper).
Step 5: Position the safety shield forward toward the roller and lock the active
bolt.
Step 6: Close the rollers with the knob on the right side of the laminator. Set the
FWD / REV switch to FWD and set the RUN / STOP switch to RUN. The films
will be fed into the machine. Check the status of lamination.
Remark: The machine will not power on without the safety shield in the
proper positions.
HOT LAMINATING
1.Turn on the machine, set the RUN / STOP switch to STOP, set the HOT /
COLD switch to HOT. The machine begin heating. Turn the temperature knob to
the temperature for whatever film is being used.
2.The laminator will be ready to operation in about 10 minutes.
1) Trial lamination
If the roll film is the first time to be used, the trial lamination is required for
perfect result. After the true temperature of the roller reach to the set temperature,
close the rollers with the knob on the right side of the laminator, set the FWD /
REV switch to FWD and set the RUN / STOP switch to RUN, let at least 250mm
of film go through the rollers before inserting the items to be laminated.
Examine the film coming out the back of machine.
Adjust the machine according to the above instructions until you have the
perfect lamination result.
2) After the trial lamination has a satisfied result, position the feed guides
according to the width of the item to be laminated, entering the item in the web
of film.
Remind: keep clear and enough space behind the machine, so that the
laminated item can come out easily, it will not wind onto the rubber roller. If
the machine is stopped for a long period, set the temperature decreased by
5-10
this will prolong the work-life of the machine.
Stop the machine after the item to be laminated pass through the roller
completely, otherwise there will be an imprint on the item.
OPERATION INSTRUCTIONS
9
