User Manual
English
For direct connection, please follow the instructions below
▪
Connect the matrix and PC using Cat.x cable
▪
Please ensure the matrix and PC are in the same network segment (The default IP address of the
matrix is 192.168.0.247, and the default network mask of the matrix is 255.255.255.0.
▪
Run the control software. Please note:
If the IP address of the PC has changed after running the
software please reboot the software.
▪
Select Network under CTRL Mode
▪
Select Search device
▪
Select the matrix to control (Once selected, the software will read the network configuration)
▪
Select Disconnected to connect to the matrix
▪
Once a successful connection is made, Status will be changed to Connected. If this is selected again
it will disconnect from the matrix.
For connection via a Network switching or routing system please follow the process above with direct
connection to a network switch between the PC and matrix. If the IP address is not obtained automatically
by the software via Automatic (DHCP) mode, please ensure the network switch supports DHCP.
Once connected the user can now progress with controlling the matrix.
Summary of Contents for 38260
Page 2: ......
