URRACO 75 D
S
ERVICE GUIDELINES
Managing director
LINDNER
Mobile Shredder GmbH
Industriestrasse 1A
D-99820 Hörselberg / Eisenach
Service hotline:
+49 (0) 36920 - 7269 - 600
Manuel Lindner
Gerhard Buhl
Walter Geiger
Page - 23 - of - 38 -
Never fill the hydraulic system directly via the cap of the hydraulic tank. Always
use the upper hydraulic pipe for this purpose. Filling via the tank allows air to
enter the hydraulic system which will cause damage to the components.
1.7.-9
Checking the Gearbox Oil Level / Changing the Gearbox Oil
The gearbox oil level must be checked daily via the sight glass; the oil level must be slightly
above the centre of the sight glass.
Change the oil while the plant is at operating temperature (not later than 15
minutes after switching off the shredder).
Pumping out the old gearbox oil
The old gearbox oil must be pumped out in the same way as the hydraulic oil is pumped out.
Refilling new gearbox oil
1. Hang the hydraulic hose of the hand-operated pump without quick-release coupling into a
container containing fresh oil.
2. Release the hydraulic hose with quick-release coupling from the gearbox and hang it into
the old oil container.
3. Flush the hand-operated pump by pumping fresh oil into the old oil container with four or
five revolutions of the hand-operated pump.
4. Connect the hydraulic hose to the oil drain plug using the quick-release coupling.
5. Pump fresh oil into the gearbox until it reaches the centre of the sight glass.
6. Remove the hydraulic hose of the hand-operated pump and screw on the protective cap.
