Linddana A/S
. Ølholm Bygade 70 . DK-7160 Tørring . T +45 75 80 52 00 . [email protected] . www.linddana.com
Brugsanvisning: TP 230 fra dato 02.11.2015 ©Copyright 2008
16
The tightening torque for the anvil bolts must be
200 Nm/20 KPm.
Use the wrench included in the
tool kit (can be purchased as extra equipment).
Unscrew the vertical anvil and remove from inside. Before inserting a new one, clean the contact
surface and the anvil carefully. Set the anvil at
1 mm
from the knives. Use a feeler gauge. Tighten
the bolts for the vertical anvil to
200 Nm/20 KPm.
Once the anvils have been turned or replaced and all bolts tightened, draw the revolving feed
roller back into place. Refit the springs using multigrip pliers (See Figure 11).
Turn the rotor several revolutions to ensure there are no objects in the rotor housing. Close the
rotor housing and replace the bolts (See Figure 13).
Figure 13 Fitting bolts in the rotor housing
