Subject to modifications
User Manual
LMC 1
9.3EN-98001-A07
LINCOLN GmbH • Postfach 1263 • D-69183 Walldorf • Tel +49 (6227) 33-0 • Fax +49 (6227) 33-259
Page 31 of 36
COBRA chain-lubrication systems, continued
Operation, continued
Adapting the parameters
Â
Press and hold the “ENTER“ key and then press “MENU“
to open the configuration mode.
You can modify the count value of every parameter using
the “UP“ and “DOWN“ keys as below:
- Press briefly ……………………….…...
±
1 count value
- Keep pressed …………………………….
±
High speed
Menu item
* t–cl *, Nipple cleaning time
The nipple cleaning time determines the time interval of
the duration of the cleaning of a lubrication nipple.
Â
Press the “UP“ or “DOWN“ key to configure the nipple
cleaning time.
- Section
1 sec. to 99 sec.
- Count value 1 sec
Â
Conclude the selection with the “ENTER“ key.
Â
Continue with menu item
* c–rn *
.
Menu item * c–rn *, Lubricating cycles
(Cycle-dependent lubrication)
The number of lubricating cycles determines how often
the chain must run through until it is completely lubricated.
Â
Press the “UP“ or “DOWN“ key to configure the number of
lubricating cycles.
- Section
1 to 9999 lubricating cycles
- Count value 1 lubricating cycle
Â
Conclude the selection with the “ENTER“ key.
Continue with the
* c–PS *
menu item.
Menu item * c–PS *, Number of pause cycles
The number of pause cycles sets the number of non-
lubricated chain cycles that must transpire between two
lubrication processes.
Â
Press the “UP“ or “DOWN“ key to configure the number of
pause cycles.
- Section
1 to 9999 pause cycles
- Count value 1 pause cycle
Â
Conclude the selection with the “ENTER“ key.
Continue with the
* c–bl *
menu item.
Menu item
* c–bl *, Number of chain links
The number of chain links determines the number of
lubrication strokes for one chain cycle.
Â
Press the “UP“ or “DOWN“ key to configure the number of
chain links.
- Section
1 to 9999 chain links
- Count value 1 chain link
Â
Conclude the selection with the “ENTER“ key.
Â
Press the “RUN“ key (> 2 sec.) to incorporate the changes
made to all menu items. Otherwise, after 30 seconds the
program reverts back to the operating mode.
Â
If you want to change a menu item again, press the
“ENTER“ key. You will once more automatically arrive at
the start of the configuration mode.
