3. Using both hands, press the
hand-held transmitter control and
the desired channel control on the
HomeLink
t
Universal Transmitter.
Do not release the controls until
step 4 has been completed.
4. Hold down both controls until
the red light begins to flash slowly
and then rapidly. Rapid flashing
indicates successful programming
of the new frequency signal.
5. Follow steps 2 through 4 to
program the remaining two
channels.
If you do not successfully program
the HomeLink
t
Universal
Transmitter after repeated
attempts, refer to
Training a
rolling code
which follows or call
toll-free customer assistance:
1–800–355–3515.
Note to Canadian residents
During programming, your
hand-held transmitter may
automatically stop transmitting
after two seconds which may not
be long enough to program the
HomeLink
t
Universal Transmitter.
If you are programming from one
of these hand-held transmitters:
•
continue to hold the control on
the HomeLink
t
Universal
Transmitter
•
re-press the hand-held
transmitter every two seconds
You may have to repeat this
function several times while
programming.
Controls and features
44
