Page 16
Page 7
TROUBLE SHOOTING
The STATUS is displaying ‘LOW SALT’, what should I do?
The recommended salt level for the Lincoln chlorinator to function properly
is
4
000 ppm. If your salt level is under this value or the water is extremely
cold, the chlorinator STATUS DISPLAY may indicate LOW SALT.
When adding salt to bring the level up to
4
000ppm. ADD IT SLOWLY
never more than one bag at a time. Allow time for the salt to disolve before
adding another bag.
Your local Pool Shop can test a sample of your pool water for salt levels.
The STATUS is displaying ‘HIGH SALT’, what should I do?
The maximum salt level for the Lincoln chlorinator is
00 ppm. If your
salt level exceeds this, or if the water temperature is exceedingly high the
chlorinator STATUS DISPLAY may indicate HIGH SALT. If the salt level is
very high the chlorinator will cease operating momentarily and will attempt
operation at a lower power setting.This feature is especially helpful if you
are away, as the chlorinator will continue operation at a reduced output
rather than shutting down altogether.
HOWEVER: If you are alerted to the fact that the chlorinator is warning
HIGH SALT levels it is recommended that you switch off the chlorinator,
dump water from the pool and fi ll the pool with fresh water until the salt
levels are reduced to the optimum
4
000 ppm.
The STATUS DISPLAY constantly indicates ‘PRIMING CELL’. What
should I do?
Check cell connection to the junction box on the rear of the control unit
Check the fi lter pump is turned on and that water is fl owing past the cell.
Check valves are open (if fi tted )
Check water level of pool
Check for skimmer box blockage
Check for air in fi lter pump
Check fi lter is clean
The CHLORINE OUTPUT is LOW or NIL, what should I do?
Check that the chlorine output has not been turned down.
Check cell connection to junction box underneath control unit
Check fi lter pump is working
Check that the salt level is
4
000ppm.
Check the water balance
MAIN OPERATING SCREEN
MODE
Displays the current MODE of
operation from the list of modes
on the following page.
Chlorine Output
Displays the current level of chlorine production as both a percentage and
as a bar graph to an accuracy of 1%.
To increase chlorine output press the [ ] button.
To decrease chlorine output press the [ ] button.
STATUS
Displays the system status.
OK
Current condition is normal
LOW SALT
Indicates when a low salt condition is present
SALT HIGH
Indicates when a high salt condition is present
PRIMING CELL
Chlorinator is waiting for pump to start and deliver
water
t
o the cell.
PUMP FAIL
Cell did not become primed in the allotted time
(only occurs if PUMP PROTECTION is enabled).
CHANGING MODES
There are two ways to change the MODE. You can cycle through OFF,
ON, and TIMER modes via the MAIN OPERATING SCREEN by pressing
the [ENTER] button. Each time the [ENTER] button is pressed the MODE
is advanced to the next and then repeats. Alternatively, you can change
the MODE via the MAIN MENU, and in so doing, will be able to invoke the
SUPERCHLORINATE and SPA modes which are not accessible from the
main operating screen.
To enter the MAIN MENU press the [MENU] button.
Use the [ ] and [ ] buttons to navigate the MAIN MENU until
the arrow indicates that you have reached MODE SELECT.
Now press the [ENTER] button.
Mode:Timer
Chlorine Output:
Status: OK
Mode Select
Chlorine Output
TimerSettings
Pump Protection
