B-2
OPERATION
WELDING CONTROLS
1. AMP METER-
Shows the current prior to welding using the
OUTPUT control dial. During welding, the meter displays the
actual output current (AMPS). A memory feature holds the dis-
play of both the AMP and VOLT meters on for seven seconds
after welding is stopped. This allows the operator to read the
actual current and voltage just prior to when welding was
ceased.
2. VOLT METER-
Shows the voltage prior to welding using the
OUTPUT control dial. During welding, the meter displays the
actual output voltage (VOLTS). A memory feature holds the dis-
play of both the AMP and VOLT meters on for seven seconds
after welding is stopped. This allows the operator to read the
actual current and voltage just prior to when welding was
ceased. While the display is being held the left-most decimal
point in each display will be flashing. The accuracy of the
meters is +/- 3%.
3. OUTPUT-
Adjusts output setting of machine
4. CONTROL-
Fine tunes the arc for optimal weld performance
5. WELD MODE SELECTOR SWITCH-
(Provides Three selectable welding modes)
STICK
TIG
CV-WIRE
6. 6-PIN CONNECTOR-
For attaching optional remote
control equipment. Includes auto-sensing remote control
circuit.
7. WELD OUTPUT TERMINALS WITH FLANGE NUT-
Provides a connection point for the electrode and work
cables.
7A. Connect work lead to 7A for STICK and TIG
welding.
7B. Connect work lead to 7B for CV welding.
8. GROUND STUD-
Provides a connection point for con-
necting the machine case to earth ground.
CROSS COUNTRY 300
FIGURE B.1
