IS425 ECN 3607
Page 8 of 13
The unit also has some built-in safety features when in measured dispense mode. These
are
Pressing the “Hot water” button at any time during the filling will stop the fill cycle.
Other siz
e receptacles can be filled be pressing and holding the “Hot Water” button
until full, similarly under-filled receptacles can be topped up in this way.
Standby
If the boiler is left unused for any length of time, turn the element off by pressing the
power
button.
Filter replacement
The filter display shows the estimated life remaining in the filter cartridge (Fig 2). A
reminder message is displayed when the filter needs changing. The boiler can be
used without a filter, but scale will quickly build up and water taste may be affected.
Fig 2
To replace the filter
Remove the drip tray from the appliance. Pull the bottom of the lower panel (Fig 1 (F))
outwards and release the two spring pins. Slide the panel downwards to remove.
Twist the base of the filter 90 degrees to the left and lower the cartridge out of the
appliance. It will contain a small amount of water,
Remove the black cap and place it on the new filter.
Re-insert the filter into the recess and lock into place by twisting to the right.
Refit the lower panel.
For EB3F/PB, hold the Fn button for 10 seconds to reset the filter life. For EB3F/PBM
hold the Fn and On/Off buttons down simultaneously for 10 seconds.
Drain off approximately 5 litres of water to remove any loose carbon particles from the
filter.
FILTER
READY
STANDBY
CLEAR
CHANGE
FILTER