F O R M O U N T I N G I N S T R U C T I O N S A N D G U I D A N C E I N U S A G E , P L E A S E S E E T H E R E L E V A N T U S E R M A N U A L S
Copyright © LINAK
2020.06
. MA-M9-02-844
. LINAK
A/S reserves the right to mak
e technical alter
ations
I/O Specifications
21
2019 © LINAK A/S
IO-Link
Input/Output
Specification
Comments
Description
IO-Link is standardised IO technology (IEC 61131-9)
for the communication with actuators. The point-to-point
communication is based on the long established actuator
connection without additional requirements regarding the cable
material. IO-Link is no fieldbus but the further development of
the existing, tried-and-tested connection technology for
actuators.
Brown
(M12 port 2)
2L+
Power supply motor +
24 VDC + (VCC)
Connect Brown to positive
Note:
Do not change the power supply polarity on the brown and
blue wires!
Power supply GND (-) is electrically connected to the housing
Current limit levels can be adjusted through BusLink
If the temperature drops below 0°C, all current limits will
automatically increase to 6A for 24V.
24V ± 10% - max. 2.5A depending on load
24V, current limit 5A
Blue
(M12 port 5)
2M
Power supply motor -
24 VDC - (GND)
Connect Blue to negative
Red
(M12 port 1)
L+
IO-Link
18 - 30 VDC +
On voltage:
18 to 30 V
M12 plug on device
M12 Plug on device
3
2
1
4
5
2L
+
2M
L-
C/Q
L+
- pin numbering and connections.
Black
(M12 port 3)
L-
I
O-Link supply -
18 - 30 VDC - (GND)
Green
(M12 port 4)
C/Q
I
O-Link C/Q
(data communication)
IO-Link is fieldbus independent and can be integrated into all
fieldbus systems worldwide.
Transmission rate: 38.4 kbaud (COM 2)
Max cable length: 15 meters
The IODD file describes the parameters, find it here:
https://ioddfinder.io-link.com
Violet
Service interface
Only BusLink can be used as service interface.
Make sure that the violet and white wires are not short-circuited
White
Service interface GND
Yellow
Not used
Please note that version 1.0 of IO-Link does not support data storage. Therefore, it is recommended to disable the
data storage feature on the PLC/IO-Link master.
Data storage is a recommended feature in IO-Link, which makes it easy to replace an existing device with a substitute.
Data storage will be released in a later software version.
