Page 45 of 71
Factory reset (only DPG1M, DPG1B and DPG1C)
Press and hold the and buttons for eight seconds to set the DPG to factory default. The LED/light strip
flashes red three times to indicate the reset is done. If a factory reset is performed, it sets the DPG back to
the configured state, i.e. all configurations made in the DPG configurator will not be reset – only the settings
changed directly on the DPG or in the app by the end users will be reset.
DPG1C only
During reset, the display lights up after five seconds, showing an arrow with a countdown [seconds] and RESET
Error codes
Cause
E53-E64
COLLISION
E41-E52
OVERLOAD
E01
INITIALISATION
Troubleshooting/FAQs
Error codes (only DPG1C)
The DPG1C shows error codes generated in the CBD6S in case of errors in the system. The most common errors
loop between the error code (EXX) and the error text, check the codes below:
Software versions before SW 1.13 only show error E01.
Figure 42: Reset to factory default (DPG1B and DPG1C)
Figure 43: Reset to factory default (DPG1M)