Instruction Manual for TECH-system type 239
______________________________________________________________________________
Page 30 of 39 june 2020 ver. 09
LINAK Danmark A/S - Mønstedsvej 9 8600 Silkeborg - Telefon 86803611 - www.linak.dk
Once you have made the changes you require, save the new configuration by pressing ARROW UP for at
least 2 seconds.
Parameters
The following parameters can be adjusted as required or desired:
1. Speed:
Set the operating speed of the actuators
2. Initialisation speed:
Set reduced speed during initialisation operation
3. Start ramp:
Set ramp time, Start
4. Stop ramp:
Set ramp time, Stop
5. Power limit:
Set the max. power limit.
6. Deviation in pulses:
Set the max. permissible deviation in pulses
7. Regulation behaviour: Set hard or soft regulation behaviour
8. Error indication:
Set activated or deactivated error indication
9. Start conditions:
Set the direction the actuators are to run after ERRORS
10. Operating mode:
Define whether pulse activating or continuous activating on push is
required
11. Power-on:
Set whether the control unit is to perform an automatic
initialisation every time voltage is connected to the control unit.
12. Auto-initialisation:
Set the starting point for automatic initialisation
13. Dual pulse mode:
Set utilisation of Dual hall pulse feedback.
14. End stop OUT:
Set maximum stroke length, OUT.
