Lilin PIH-816III, Instruction Manual

Page: 9 / 26

4. ID & RECEIVER SETUP:
To set camera ID and Receiver number.
5. ALARM SETUP:
To set up corresponding alarm and camera.
6. ALARM SETUP:
To set up alarm switching and dwell time.
7. DOME SETUP:
To set the preset positions of Fast Dome Camera.
If password is assigned to the system, message below will be
displayed when the SETUP key is pressed. To enter SETUP
mode, password must be entered correctly. If password is
incorrectly entered, further process will not be allowed.
If password is forgotten, password must be deleted using
SW1 PRESET located on PC board under is matrix turned
on.(open the cover of matrix) See diagram below.
SETUP MENU
1. SYSTEM SETUP
2. SEQUENCE TABLE
3. MONITOR SETUP
4. ID & RECEIVER SETUP
5. ALARM SETUP
6. ALARM TIME SETUP
7. DOME SETUP
ENTER ITEM
SYSTEM SETUP VER 1.0
ENTER SYSTEM PASSWORD
AND PRESS ENT TO CONFIRM
MERIT LI-LIN CO, LTD
SW1 RESET
PIH-832A
Deleting
Password
Deleting password
& System Setup
Setting Time & Date
To set or change date & time:
SYSTEM SETUP
1. DATE / TIME SETUP
2. PASSWORD SETUP
3. PASSWORD CLEAR
ENTER ITEM 1
DATE / TIME SETUP
CURRENT DATE / TIME
13/10/98 19
08 54
NEW DATE / TIME
13/10/98 19
08 54
SETUP MENU
1. SYSTEM SETUP
2. SEQUENCE TABLE
3. MONITOR SETUP
4. ID & RECEIVER SETUP
5. ALARM SETUP
6. ALARM TIME SETUP
7. DOME SETUP
ENTER ITEM 1
Date & Time
(Hr/Min/Sec)
New Date & Time
(Hr/Min/Sec)
1. Press numeric key 1 from SYSTEM MENU. To enter SYSTEM SETUP.
2. Press numeric key 1 from SYSTEM SETUP. To setup date and time.
3. To setup or change date and time. Enter time and date using blinking cursor. Use the Joystick to move
blinking cursor.
4. Press ESC key, when finish setting.
7