LDT10
The
Target position
field allows to set the target position, i.e. the position that
the actuator is commanded to reach. The value is expressed in pulses. See the
“
Target position
” register in the “User's guide” of the specific actuator.
After having set the target position you can start and check the motion of the
axle to the target position by pressing the following keys:
JOG -
,
JOG +
,
START
and
STOP
.
After having set the required target position and reached it (
Position
=
Target
position
page and then save the target position in
the wished recipe by pressing the
key.
For a comprehensive description of the JOG, START and STOP functions please
refer to the “
Control Word
” register in the “User's guide” of the specific
actuator.
WARNING
As soon as you press the
JOG
and
START
keys the axle starts moving. Before
pressing the keys please make sure that the movement can be achieved with
absolute safety and no risk to cause injuries to the operators and damages to
the equipment can arise.
WARNING
Please note that pressing the
STOP
key will cause a normal and sequential halt
of the actuator to be forced; the actuator will be commanded to stop respecting
the set deceleration value; thus its stop will not be immediate.
Press the
key in the menu at the top of the page to enter the
page. For complete information please refer to the “5.5 Network page” section
on page 25.
Press the
key in the menu at the top of the page to move back to the
page. For any information refer to the “5.10 Home page” section on page
MAN LDT10 E 1.2
HMI interface
28 of 44
